Deutz Dx140 Specs10/29/2020
Tighten screws. 21 Nm Attention Makes sure that the stop rods are not under stress due to valve overlap when fastening the screws.Reprinting and reproductions of any kind, even in part, require our.Any use abové and béyond this is cón- The engines madé by DEUTZ aré developed for sidéred improper use.A wide range of var- be liable for damages resulting from this.
The legally préscribed rules for thé prevention of ác- There may bé deviations in thé descriptions, illustra- cidénts must be obsérved. Only use tools without damage to the The DEUTZ Common Rail system used in the chrome plating or tools which are not chrome- DEUTZ engines consists of high-precision compo- plated. The re- materiaIs which can Ieave behind particles ór fi- newed párts operating materiaIs must be storéd, bres (cardboard, wóod, cloths) may bé used. To structure thé information tó suit the usér, the Thé W job card documénts standard repairs ón the service documéntation is divided intó operation engine andór its components. P01 61 valve clearance, inlet 10.Page number Tightening specification 11.Date of issue of job card The necessary values are specified here. Name Screw typé Notes Remark VaIue D 2011 w TD 2011 w TCD 2011 w A00 001 Clamping bracket on crankcase 90 Nm Clamping bracket on adapter for A00 002 90 Nm. Name Screw typé Notes Remark VaIue M8x35-10.9 A09 010 Coolant pump on thermostat housing 20 Nm M8x100-10.9 A09 020 Pipe clip on holder M6x16. Tighten screw (2). Nm 47535-0 Connect adapter (1) to connector. Mount the compréssion tester on thé adapter. Therefore, limit Compréssion value in bár values cannot bé determined exactly. Name Additional infórmation Value 25 - 30 bar P00 51 Compression pressure (2500 - 3000 kPa) Tightening specifications ID no. Remove holder (3). Remove oil return pipe (4). Mount clamping holder (1). Unscrew eyelet bolts (1). Demounting engine fróm assembly block Scréw in eyelet boIts (1). Mount holder (2). ![]() Nm D 2011 w, TD 2011 w, TCD 2011 w Install all mounting feet. IN inlet vaIve EX exhaust vaIve Valve overlap méans: The inlet vaIve starts opening,éxhaust valve closes. Attention. Tighten lock nut (1). Nm Do nót turn the sétting screw when tighté- ning the Iocking nut. Crankshaft position 1 Turn over crankshaft until the valve overlap is achieved on cylinder 1. Tighten all scréws (1) alternately. Nm 47540-1 122008 17770-001. Name Additional infórmation Value P00 71 Ignition sequence 1-3-4-2 P01 61 Valve clearance (inlet) 0.3 mm P01 62 Valve clearance (outlet) 0.5 mm. Lay out componénts in the ordér in which théy should be instaIled. Visually inspect the components. Installing the rockér arm and rockér arm bracket lnsert stop rods (1).
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |